Прогуглив нашел это:
Reset the fuser page count.
Next you will reset the fuser count.
There are 2 methods for resetting the page count.
The "Short Cut" Method
The "short cut" method should work if your machine was previously showing the error message, "REPLACE FUSER KIT." If that message was not displaying, the shortcut method will not work -- you can proceed to the next method below.
1. Close the top cover, and turn the printer on. After a short while, the control panel should
display NEW FUSER KIT.
2. Press Down Arrow button to highlight YES.
3. Press Checkmark button to select YES.
4. Press Up Arrow button to reset the fuser count.
The Long Method
If your machine was not displaying the message REPLACE FUSER KIT, you will need to reset the fuser count manually through the control panel.
1. Press Checkmark button to open the MENUS.
2. Press Down Arrow button to highlight CONFIGURE DEVICE.
3. Press Checkmark button to select CONFIGURE DEVICE.
4. Press Down Arrow button to highlight RESETS.
5. Press Checkmark button to select RESETS.
6. Press Down Arrow button to highlight RESET SUPPLIES.
7. Press Checkmark button to select RESET SUPPLIES.
8. Press Down Arrow button to highlight NEW FUSER KIT.
9. Press Checkmark button to select NEW FUSER KIT.
10. Press Down Arrow button to highlight YES.
11. Press Checkmark button to reset the fuser count.
Добавлено спустя 58 минут 22 секунды:Разобрался как делать)
Сбрасывается счётчик в настройках принтера: Обслуживание - Сброс -> Установлен новый НАБОР ТЕРМОЭЛ. -> Да
