This guy is bent and not working correctly

Looking for a dump for this machine if anyone has it

Got dumps for MG6850 the only difference is the cartridges, can upload if you want them.

Same printer as XP-241 if you find a chipless dump for it

Yes i understand that, but the power ink flushing is for cleaning the printhead, maybe you have air bubbles in the cyan tube and the ink is not flowing like it should be.

What about initial ink charge?

You ruled out everything already so it must be the printhead

They most likely shorted a data line with a high voltage line, if you have another printhead you check resistance between the pins and

compare.

Check if these resistors have their correct values

Lately i've seen a lot of broken paper separator holder on this model, causing the same symptoms you're describing or might be lucky and something fell in the paper pathing jamming the rollers.

Any one could share please?

i've had a similar case on a CANON MG5750 and the problem was that someone had broken some lines on the FFC of the printhead/carriage unit when they tried to pull the carriage unit to the left.

Доброго времени!!! Canon Pixma TS5040 Сей аппарат пришел с проблемой парковки... Отдавали в какой то "пивонЭрский" сервис... Там якобы сделали, но твсе равно не работает... Снял все крышки и сканер, и впал в ступор... Как дальше разбирать, чтоб потом собрать.. Вопрос, может есть у кого на...

6000 error means that the pump is stuck by a foreign object can be paper or whatever got stuck there and it's not operating correctly, also check on the mainboard side if there's no loose connections of FFC.

Could be the small resistors that are around the printhead FFC connector in the mainboard, those can fail too and cause these errors.

Can you post the WICReset or Printhelp last fatal error?