#{title}

**Xitkom** » Пт авг 28, 2020 4:45 am

Здравствуйте, уважаемые форумчане.

Сий аппарат поймал воздух после заправки картриджей. Был у кого опыт прокачки системы? Как правильно ее сделать?

Прочистка стандартная проблему не решает. Шланги похоже идут напрямую в голову.

**3cxmoskva** » Пт авг 28, 2020 10:28 pm

do you have original black cartridge? how much printed pages had printer? can you check fuse of print head on main board? which error you have in adj program ? I think new firmware not helping you, also CL1,CL2 cleaninig. it sounds like maintenance pump system. can you try ink charge ?

**Xitkom** » Пн авг 31, 2020 2:58 am

The cartridge is original, but refill

ed. 40,000 pages were printed. The printhead works, but not all nozzles work. There is air in two of the four tubes. Pumping through PrintHelp does not give results.

**3cxmoskva** » Пн авг 31, 2020 8:01 am

Can you put picture of nozzle check here ?

**3cxmoskva** » Пн авг 31, 2020 9:50 am

after cartridge unit you have 2 diafragma pumps and 2 buffers. Nozzle check, do you have 1 and 3 or. 2 and 4 black band ?
Your old cartridge had correct nozzle check ?

**Xitkom** » Пт сен 04, 2020 1:59 am

3cxmoskva писал(а):Can you put picture of nozzle check here ?

**Xitkom** » Пт сен 04, 2020 2:05 am

3cxmoskva писал(а):after cartridge unit you have 2 diafragma pumps and 2 buffers. Nozzle check, do you have 1 and 3 or. 2 and 4 black band ?

**Xitkom** » Пт сен 04, 2020 2:11 am

Air bubbles are visible in tubes 1 and 3. 2 and 4 are empty. The original cartridge worked well. Then it was refueled and the chip was changed. Until the end of the resource worked normally. After the second refueling, I printed about 5000 sheets and began to strip. I think that when refueling the cartridge started the air that got into the system. How to remove it from there is not clear. In the l-series models, you could pump buffers, but how do you do it here?

**3cxmoskva** » Вс сен 06, 2020 4:12 pm

You have a problem with all 4 bands in print head. I would try ink flushing CL1 with adjustment program.Print head is suspicious.

**Xitkom** » Пн сен 07, 2020 3:30 am

All four tubes must have ink in them? Or only 1 and 3?

**3cxmoskva** » Чт сен 10, 2020 4:34 pm

Only 1 and 3, 2 and 4 are empty.

**Xitkom** » Ср сен 16, 2020 6:05 am

Do you have adjustment program for this printer?

Epson M5799 воздух в системе

Кто сейчас на форуме

#{title}