


В режиме дебага оригинальная прошивка 3.00.01.09 (как и откусаная до $KER)никак не заливается -
Source Checksum is valid
New F/W Version : 3000109
[Error] orginal image uncompress error -3
Downloaded Image is not Valid
Reset Target and Run Flash Writing Program Again.
Вот полный лог -
Boot&Mon. CheckSum OK!
[SFLASH_InitFLASH][NG]
[ POWER ON Booting... ]
Press any key to execute Monitor Program within 1 sec...
<CPU:375Mhz RAM:166Mhz SysClk:125Mhz DDR2>

START-UP MODE : Monitor Program
Boot into pROBE+ like stand-alone mode
[Type 'help' to see command info.]
Version : Ver.1.20 (BlueMT) 2011-04-27

Do you want to download from external port?[N] : n
pROBE+> fl
Upgrade Flash ROM Image
[SFLASH_InitFLASH][NG]
FlashCheckSum
{
check sum start address : 40060000, count : 00014FFE
check sum : 0000A5A5
} /* Checksum End
==> Now program restarted on the RAM to program flash ROM(0x40060000)
jump to 0x40060000
Flash Data Download Address : 0x40100000
===============================
Start flash_writer
===============================
[SFLASH_InitFLASH][NG]
verify_Image : 0x40100000
i_header->pul_start_addr : 0x00000000
i_header->ul_count : 0x00000000
model : 0x00000000
flash type : 0x00000000
image type : 0x00000000
temp_buf :
SIG :
Can not find sig


Control register = 0x000510F8
Icahe : ON
Dcahe : OFF
MMU : OFF
Download Image from PC
{
Ready to download from Parallel/Usb/Serial (0x40100000)

Samsung OTG, 2006
Link ID : [00000000]

Drv "design ware core" USB download<HS><HS><EPB_RX 0x00000200>
Image includes PJL(0000001B) -> Waste 92 bytes
[[4194424 Bytes received]] - Complete Downloading
} /* Download End */
verify_Image : 0x40100000
i_header->pul_start_addr : 0x00000000
i_header->ul_count : 0x00400000
model : 0x05000041
flash type : 0x00020002
image type : 0x00000000
temp_buf : $KER
SIG : $KER
FlashCheckSum
{
check sum start address : 4010001C, count : 00400000
check sum : 0000A5A5
} /* Checksum End
Source Checksum is valid
New F/W Version : 3000109
[Error] orginal image uncompress error -3
Downloaded Image is not Valid
Reset Target and Run Flash Writing Program Again