T.E.S.T.C.O.P.Y.

NVRAM initialization
Performing an NVRAM initialization resets the following settings and information:
● All menu settings are reset to factory default values.
● All localization settings, including language and country/region, are reset.
CAUTION: All onboard network settings are also reset. Be sure to print a configuration page before
restoring defaults. Make note of the IP address that is listed on the Jetdirect configuration page. You
might need to restore the IP address after an NVRAM initialization.
After performing an NVRAM initialization, reconfigure any computers that print to this product.
Uninstall and then reinstall the product software on the computers.
1. Turn the product off.
2. Touch the right arrow button. Hold this button as you turn the product on.
NOTE: The right arrow button is not visible when the product is off, but it is still active. Note its
position before you turn off the product.
3. When Permanent storage init. appears on the display, release the right arrow button.
When the product has finished the NVRAM initialization, it returns to the Ready state.