Модератор: vetal
dviz писал(а):номер ошибки четырёхзначный должен быть.. попробуйте перевести язык на дисплее на английский. Должно получится что-то вроде
[PRINTER ERROR]
Service Call-####
ошибки начинающиеся на 6:
6000 Broken heater lamp error
The temperature won’t rise by 1 degree Celsius during warming up and the heater is turned on for 5 seconds. The temperature won’t rise by 1 degree Celsius during printing and the heater is turned on for 5 seconds with the duty cycle more than 60%
[Defective fuser thermistor.] [Broken thermal cutout or heater lamp.] [Defective engine/high voltage PWB.]
6010 Fuser low temperature
After the fuser heater lamp is turned on, the temperature at the upper fuser roller lower than 100 °C/212 °F continues for 30 s
[Defective fuser thermistor.] [Defective engine/high voltage PWB.]
6050 Broken fuser thermistor
The thermistor AD value is less than 1 for 600 m
[Defective fuser thermistor.] [Defective engine/high voltage PWB.]
6400 Zero cross signal error
While fuser heater ON/OFF control is performed, the zero-cross signal is not input within 3 s.
[Defective the power source PWB.] [Defective the engine/high voltage PWB.]
Вернуться в Принтеры, МФУ, факсы, копиры формата A4
Сейчас этот форум просматривают: Anton52rus и гости: 200