T.E.S.T.C.O.P.Y.

BYTE Read or write BYTE in target memory
CFI_DUMP Display CFI data for current chip as hex dump
CFI_INFO Display CFI data for current chip in verbose mode
CPSR Read or write Current Program Status Register
COMM Read or write DCC data
CPU Get or set CPU type for current device
DBS Show all EICE-RT registers data (DeBug Status)
DEVICE Load new device profile
DUMP View memory dump
DUMP_NAND View NAND flash memory dump
EICE[n] Access to EmbeddedICE-RT registers
EXECUTE Write file to memory and execute
FLASH_ERASE Erase flash from custom address and size
FLASH_ID Read flash ID at custom address
FLASH_READ Save selected flash region to to file
FLASH_WRITE Write selected flash region
GO Execute CPU from address
HALF Read or write HALF (2 bytes) in target memory
HALT Halt CPU core with debug request
HALT_AND_READ Halt target using loaded device profile.
IDCODE Show device IDCODE of connected target
INSTALL_DRV Install JTAG USB rs
ISOLATE Select device in JTAG chain
JTAG_LOW Set all JTAG outputs low
NAND NAND configuration
PSR Show Current and Saved Program Status Registers
REGS Show all CPU registers for current PSR
REPEAT Repeat executing script from this line
RESET Reset all connected devices and read params
RTCK Display RTCK sampling freq. and react time
RUN Execute CPU from saved with STOP debug entry point
Rn Read or write CPU registers
SAVEMEM Save target memory to file
SCR Load and execute script file.
SLEEP Pause in script in ms.
SPSR Read or write Saved Program Status Register
STOP Halt CPU with entry point saving
TCK Read or write JTAG TCK value in Hz
UNINSTALL_DRV Uninstall JTAG USB rs from system
VDD Read or write JTAG voltage level
VREF Display target voltage level
WAIT_DBG Wait for core debug return with timeout
WORD Read or write WORD (4 bytes) in target memory
WPOINTn Access to EmbeddedICE-RT Watch and Breakpoints
WRITEMEM Write file to target memory