T.E.S.T.C.O.P.Y. • Просмотр темы - Kyocera 3252ci ошибка С2840

Kyocera 3252ci ошибка С2840

Решение возникающих проблем.

Прилепить пост

Сообщение darknebola » Чт янв 16, 2020 6:29 pm

Всем доброго времени суток, поделитесь пожалуйста документацией на данный аппарат, столкнулся с ошибкой с2840, у клиента места мало его делать, а в офис тягать 100кг с 4 этажа проблематично, хотелось бы подойти во все оружие к ремонту) спасибо за ранее
Аватар пользователя
darknebola   
Разобрал струйный принтер
  • Не в сети

Прилепить пост

Сообщение Goldwater » Чт янв 16, 2020 8:04 pm

Оружие есть и без документации
Belt cleaning motor error
Causes:
1. The motor FG pulse of is not input for 2s continuously during the motor operation.
2. The FG pulse exceeding 4000rpm was detected 10 times continuously.
3. The motor speed was out of the target speed (+/- 6.25%), and the condition was continued for 2s.
Remedy: 1 Checking the primary transfer unit
The primary transfer unit is not properly installed. Reinstall the primary transfer unit.
2 Cleaning the primary transfer cleaning section
The roller in the primary transfer cleaning section does not rotate properly. Remove the waste toner remaining in the primary transfer cleaning section.
3 Checking the wire
The wire is not properly connected. Reinsert the following wire connectors, and replace the wires when they have no continuity.• Belt cleaning motor - Transfer PWB• Transfer PWB - Transfer connection PWB• Transfer connection PWB - Feed image PWB
4 Checking the wire
The wire is not properly connected. Reconnect the wire connectors between the feed image PWB and the engine PWB. If the wires are pinched or it have any damage, fix or replace them.
5 Checking the belt cleaning motor
The belt cleaning motor is not properly attached, or it is faulty. Reattach or replace the belt cleaning motor.
6 Primary transfer unit replacement
The cleaning d rive section in the primary transfer unit is faulty. Replace the primary transfer unit.
7 Replacing the feed image PWB
The feed image PWB is faulty. Replace the feed image PWB.
8 Firmware upgrade
The engine firmware is faulty. Upgrade the engine firmware to the latest version
9 Replacing the engine PWB
The engine PWB is faulty. Replace the engine PWB.
Чего ж тут непонятного?
Аватар пользователя
Goldwater   
Избран тонером
  • Не в сети


Вернуться в Принтеры, МФУ, копиры формата A3

Кто сейчас на форуме

Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 52

вверх
вниз
cron
x

#{title}

#{text}