И нить и решетка важные компоненты, одна без другой работать не будут. Счетчик обнулять надо, но не ранее чем через 150 000 отпечатков:
U110Checking the drum count
Description
Displays the drum counts for checking, clearing the figure.
Purpose
To check the drum status. Also used to clear the count after replacing the durm during regular maintenance.
Since the count was cleared before shipping, do not clear it when installing.
A drum count value less than
150K, however, cannot be cleared.Method
1. Press the start key. The drum counter count is displayed.
Setting
1. Select [COUNT] using the cursor up/down keys.
2. Change the count using the numeric key.
3. Press the start key. The count is set.
Clearing
1. Select [CLEAR] using the cursor up/down keys.
2. Press the start key. The count is cleared.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Добавлено спустя 5 минут 27 секунд:Kyocera Taskalfa 181 полоситНо если счетчик аппарата перевалил за 150 000 отпечатков, то необходимо (после обслуживания) обнулить этот счетчик:
U251Checking/clearing the maintenance count
Description (
Описание)
Displays, clears and changes the maintenance count.
Purpose (
Цель)
To check the maintenance count. Also to clear the count during maintenance service.
Method (
Методика)
1. Press the start key. The maintenance count is displayed.
Setting
1. Select [COUNT] using the cursor up/down keys.
2. Change the count using the numeric key.
3. Press the start key. The count is set.
Clearing
1. Select [CLEAR] using the cursor up/down keys.
2. Press the start key. The count is cleared.
Completion (
Завершение)
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
А затем сбрасываете счетчик драма, как написано выше.