Добавлено: Ср ноя 21, 2012 1:51 pm
Господа все сделал по инструкции дебаг проверил на себя вроде работает все норм но столкнулся с такой ситуацией:- Код: выделить все
Loading boot application...
[NG0x00000000]
Boot : Egmont F(C3N) V0.12 08-01-2011
<Winbond W25Q64>
Verify Image : 0x02780000
i_header->pul_start_addr : 0x00000000
i_header->ul_count : 0x00000000
Model : 0x00000000
Flash Type : 0x00000000
Image Type : 0x00000000
temp_buf :
SIG : $IMG
Can not find signature
Press any key to execute Monitor Program within 1 sec...
GO MonitorEntry
----------------------------------------------------------------
START-UP MODE : Monitor Program
[Type 'help' to see command info.]
Version : Egmont F(C3N) V0.12 08-01-2011
----------------------------------------------------------------
Do you want to download from external port?[N] : n
No
vxshell> fl
Upgrade Flash ROM Image
===============================
Start flash_writer
===============================
<Winbond W25Q64>
Verify Image : 0x02780000
i_header->pul_start_addr : 0x00000000
i_header->ul_count : 0x00000000
Model : 0x00000000
Flash Type : 0x00000000
Image Type : 0x00000000
temp_buf :
SIG : $IMG
Can not find signature
Download Image from PC
{
Ready to download from Parallel/Usb/Serial (0x02780000)
-------------------------
Samsung OTG, 2006
Link ID : [4F54281A] = [4F542000]
-------------------------
....Done.<HS><HS>
Image includes PJL(0000001B) -> Waste 92 bytes
[[8388728 Bytes received]] - Complete Downloading
} /* Download End */
Verify Image : 0x02780000
i_header->pul_start_addr : 0x00000000
i_header->ul_count : 0x00800000
Model : 0x05000063
Flash Type : 0x00120002
Image Type : 0x00000000
temp_buf : $KER
SIG : $IMG
FlashCheckSum
check sum start address : 0278001C, count : 00800000
check sum : 0000A5A5
} /* Checksum End
Source Checksum is valid
Boot image!
Found new kernel(0x027C001C)!!!!
Decompress ....................................................................
................................................................................
...... Done
Decompress ....................................................................
................................................................................
...... Done
cur : 0x8, new : 0x8
This is a valid image.!!!!
Соответственно аппарат застывает в том же положении что и был, подскажите что делаю не верно?
