Приветствую Та же самая беда у меня, не обновляется 8 прошивка, помогите плз... уже много что попробовал ничего не помогло, регион менял уже раз 5 ...
Прошивка у меня У аппарата V3.00.01.08F аппарат печатает с чипом, без блокируется... прошивка виснет на This is a valid image.!!!!
Loading boot application...
[NG0x0000FDB1]
Boot : Egmont(C3N) V0.12 08-01-2011
<Winbond W25Q32>
Press any key to execute Monitor Program within 1 sec...
GO MonitorEntry
------------------------------------------------------------START-UP MODE : Monitor Program
[Type 'help' to see command info.]
Version : Egmont(C3N) V0.12 08-01-2011
------------------------------------------------------------Do you want to download from external port?[N] : n
No
vxshell> fl
Upgrade Flash ROM Image
===============================
Start flash_writer
===============================
<Winbond W25Q32>
Verify Image : 0x01900000
i_header->pul_start_addr : 0x00000000
i_header->ul_count : 0x00000000
Model : 0x00000000
Flash Type : 0x00000000
Image Type : 0x00000000
temp_buf :
SIG : $IMG
Can not find signature
Download Image from PC
{
Ready to download from Parallel/Usb/Serial (0x01900000)
---------------------Samsung OTG, 2006
Link ID : [4F54281A] = [4F542000]
---------------------....Done.<HS><HS>
Image includes PJL(0000001B) -> Waste 92 bytes
[[4194424 Bytes received]] - Complete Downloading
} /* Download End */
Verify Image : 0x01900000
i_header->pul_start_addr : 0x00000000
i_header->ul_count : 0x00400000
Model : 0x05000063
Flash Type : 0x00130002
Image Type : 0x00000000
temp_buf : $KER
SIG : $IMG
FlashCheckSum
check sum start address : 0190001C, count : 00400000
check sum : 0000A5A5
} /* Checksum End
Source Checksum is valid
Boot image!
Found new kernel(0x0194001C)!!!!
Decompress ....................................................................
... Done
Decompress ....................................................................
... Done
cur : 0x8, new : 0x8
This is a valid image.!!!!
